4 bookshelf 2 floor surround sound wiring

While some rare rooms may allow you to run cabling in two different directions to get to your surround speakers, it’s more likely that you’ll be running two pairs of cables all the way around.

Lay out your cabling-from your AV electronics all the way to your surround speakers.

You can use this to hide your cabling and get it out of the way.

Note the gap between the carpet tack strip and the baseboard, and also note any gap underneath the baseboard molding as well.

Using a pair of pliers, pull up the carpet from the area just behind your AV gear where your speaker wiring will begin its journey.

The basic steps to installing wiring using this method: Recommended tools: Pliers, screwdriver, razor knife, fish tape, tape measure, wire strippers Steps to Installing Speaker Wire Under Baseboards Also, baseboard molding is typically installed slightly off the floor, leaving you yet another channel in which to tuck cabling. These tack strips are typically laid a half-inch from the wall, giving you a nice channel behind them in which to lay wiring. Even then there are options.Ĭarpets are laid down through the use of tack strips. This really is the simplest way for running wires for surround sound speakers if you have a carpeted room, and you can get from one location to another without encountering a non-thresholded doorway. Running Surround Sound Wires via Baseboards and Baseboard Molding

I’ll give you some thoughts and pointers on each, and hopefully this will serve as a great guide in getting the wiring in place should you find yourself wanting to add surround speakers to your home. Obviously, wiring up a home in new construction is the best method of all, but that’s simply not where most of us find ourselves.

In every situation I’ve found myself, there never been a time where one of these three methods (or a combination of all three) didn’t allow me to get from point ‘A’ to point ‘B’ in a listening room. Running surround sound wires using crown molding.Wiring surround sound speakers through a crawlspace or attic access.Running surround sound wires via baseboards and baseboard molding.

There are many different ways for running wires for surround sound speakers, taking them from one part of a room to another. I’ve found that you can summarize the methods under three main categories: Some wiring jobs have been more difficult than others, but there’s always a solution if you apply some patience and enough effort. It’s not as hard as it sounds, and there has never been a case where I haven’t been able to figure out a way to successfully execute running wires for surround sound speakers located in the back of a room. But then they lament about running the wires, and I have to interject. When my friends start asking about adding surround sound speakers I get excited.

4 bookshelf 2 floor surround sound wiring